How to disassemble and install the LED downlight
Introduction of led downlights
led downlights is actually a relatively common light fixture with light gathering, generally used for general lighting or auxiliary lighting.
led downlights can provide comfortable, soft and functional basic lighting for commercial lighting, in addition to lamps in the installation of laying, pay attention to the spacing of lamps, ground illumination and uniformity.
Removal and installation of led downlights
The disassembly of led downlights
1, first of all to cut off the power supply at home.
2, by hand to screw down the bulb, so as not to break when disassembled.
3, led downlights fixed is generally used spring snap barb type fixed, as long as the led downlights pull down hard to remove.
4, cut off the led downlights and power connection cable, led downlights can be disassembled.
Installation of LED downlights
1、First determine the size of the LED downlights, and the size of the hole that needs to be cut in the ceiling.
2、According to the size of the opening, make a mark in the place where the hole needs to be opened, and then use the hole opener to make the hole.
3, after the hole is open, connect the LED downlights with the reserved wires in the ceiling.
4, after connecting the power cord and then put the LED downlights spring clips vertically into the open ceiling holes, the LED downlights on both sides of the spring clips to expand, stuck in the ceiling above the installation can be completed.
Specifications of LED downlights
LED downlights generally have 2 inch, 2.5 inch, 3 inch, 3.5 inch, 4 inch, 5 inch, 6 inch, in addition to 9 inch, 10 inch, 12 inch.
LED downlights installation and use precautions.
1, before installing the product, please read the instructions carefully, in addition to the installation of lamps and lanterns before, be sure to cut off the power.
2, check whether the packaging is complete, there is no damage to the.
3, installation to determine whether the installed ceiling, whether there is a 2 cm high clearance, as far as possible from the wall with heat sources, in addition to the wiring is best to separate the alignment.
4, the connection line on the lamps and lanterns can be passed through the drill hole, the installation of lamps and lanterns when the connection line to avoid excessive tension, do not make the connection line knot.